Modalità WISP:
In modalità WISP, il router consente a più utenti di condividere la connessione Internet da WISP. I dispositivi della porta LAN condividono in questo modo lo stesso IP dal WISP tramite la porta wireless. Quando è connessa a WISP, la porta wireless funziona come porta WAN.
Topologia di rete comune:
Passaggio 1: Apri un browser web e vai a http://cudy.net o http://192.168.10.1.
Per i dettagli, fare riferimento a Come accedere all'interfaccia web di Cudy Router?
Passaggio 2: Apparirà la finestra Configurazione rapida, scegli "WISP", quindi vai su "Avanti".
Passaggio 3: Scegli il tuo "Fuso orario".
Passaggio 4: Seleziona la rete host che desideri estendere. Fai clic su "Connetti".
Oppure fai clic su Impostazioni generali->WISP->Abilita e quindi seleziona la rete host che desideri estendere.
Passaggio 5: Inserisci la password wireless della rete host.
Nota: Assicurati che la password wireless digitata sia corretta, altrimenti la configurazione non potrà avere successo.
Passaggio 6: Personalizza il nome e la password della rete wireless o mantienili predefiniti.
Passaggio 7: Fai clic su "Salva e applica" per completare la configurazione.
Passaggio 8: Attendi qualche secondo per il riavvio del sistema, quando viene nuovamente visualizzata la pagina di accesso, puoi goderti Internet.
83 commenti
@Dear Kyle,
If you enable both WAN connection and WISP connection. The WAN connection will be main connection. The WISP connection will be a backup. So if you want to switch to WAN connection. You don’t need to disable WISP. But if you want to switch to WISP connection. You need to disable WAN or disconnect from the internet.
“I have an AX3000 router which needs to work in both WISP mode and with direct Ethernet port connection due to local conditions. It works with both setups if I manully change the configuration and reboot the router. My question is whether I need to enable/disable WISP when switching back and forth or will the router automatically switch if I leave WISP enabled and subsequently connect with cable to our local Ethernet network via the WAN port. My tests trying this have been inconsistent and I can’t verify it is the router or the local network configuration.”
I have an AX3000 router which needs to work in both WISP mode and with direct Ethernet port connection due to local conditions. It works with both setups if I manully change the configuration and reboot the router. My question is whether I need to enable/disable WISP when switching back and forth or will the router automatically switch if I leave WISP enabled and subsequently connect with cable to our local Ethernet network via the WAN port. My tests trying this have been inconsistent and I can’t verify it is the router or the local network configuration.
@Dear Paulo,
We have plan to add this function on next firmware 2.5.×. In addition, you need to the backhaul Wi-Fi connection will use the same channel as you set on the main Wi-Fi, can’t be changed.
“WR11000 does no allow yet to change the wifi channel manually. in WISP or wireless extender. When do you expect to make available the firmware correction?”
WR11000 does no allow yet to change the wifi channel manually. in WISP or wireless extender. When do you expect to make available the firmware correction?
@Dear Trent,
OK, We will send you later.
“Dear Support,
The email I used in this comment is my email address.
Thank you”