1. Scarica e decomprimi il file da qui.
2. Scarica il firmware più recente da sito ufficiale e rinominarlo in "recovery.bin".
3. Spegni il router. Scollega l'alimentatore o premi il pulsante POWER.
4. Collega il tuo computer alla porta LAN del router con un cavo Ethernet.
5. Configura manualmente l'indirizzo IP del tuo computer su "192.168.1.88".
6. Esegui "tftp32.exe".
7. Esegui "netsh advfirewall set allprofiles state off" nella riga di comando per disabilitare il firewall di Windows, altrimenti tftp verrà bloccato.
8. Premi il pulsante/foro "Reset" e tienilo premuto. Prima di accendere il router e prima che tftp inizi a scaricare il firmware, non rilasciare il pulsante/foro "Reset".
9. Accendere il router.
10. Quando tutte le luci lampeggiano velocemente o quando tftp inizia a scaricare il firmware, puoi rilasciare il pulsante/foro "Reset".
11. Quando la luce lampeggia lentamente, l'aggiornamento è completo.
12. Ripristina l'indirizzo IP del tuo computer in modo che sia un IP dinamico.
13. Fatto.
144 commenti
Please, contact me. I did all the steps and was unable to repair my Cudy wr1300. It’s seems that the firmware was successfully installed on the router but this did not change anything. I still have not gotten an IP address
Hi. Unfortunately, I didn’t find any email.
@Ahmad,
Dear Customer,
Thank you for contacting Cudy support team.
Our technical support has contacted you via email. Please check.
“Hi, why I couldn’t download any files? got 404”
Hi, why I couldn’t download any files? got 404
@Alexander
Dear Customer,
Yes, you are right.
“OK, answer this myself (for TR3000 v1.0):
1. Find and download tftp32.exe
2. make directory “tftpboot”
3. put tftp32.exe AND the firmware (renamed to “recovery.bin”) into that directory
4. connect your PC to the LAN-port of the device
5. set your LAN IP to 192.168.1.88 like described here.
6. disable windows firewall (can do this with click and point in windows)
7. start tftp from the directory in step 2. and leave that window open
8. press reset-button on the device and then connect it to power/power on, keep pressed and wait, until it starts blinking/downloading the firmware to the device (in my case this was done after 3 seconds)
9. Enable firewall again, enable dynamic config (DHCP) on your lan port again, re-connect your lan and start to configure your Cudy device”