WISP 模式：
在 WISP 模式下，路由器允許多個使用者共享 WISP 的網路連線。 LAN 埠設備透過無線連接埠與 WISP 共用相同的 IP。連接到WISP時，無線連接埠充當WAN連接埠。
常見網路拓樸：
第1 步： 開啟網路瀏覽器並前往 http://cudy.net 或 http://192.168.10.1.
詳情請參考 如何登入Cudy Router的Web介面？
第2 步： 將彈出快速設定窗口，選擇"WISP"，然後前往"下一步"。
第3 步： 選擇您的"時區"。
第4 步： 選擇您要擴充的主機網路。點選"連接"。
或點選 常規設定->WISP->啟用 然後選擇您要擴充的主機網路。
第5 步： 輸入主機網路的無線密碼。
注意： 請確保您輸入的無線密碼正確，否則設定無法成功。
第6 步： 自訂無線網路名稱和密碼或保留預設值。
第7 步： 點選"儲存並套用"完成設定。
第8 步： 等待幾秒鐘系統重新啟動，當再次彈出登入頁面時，您就可以享受網路了。
49 則留言
Cudy ap3000 outdoor v1
Came with firmware 2.2.6 (not available on website for download but only updating from interface)
Yesterday tried with firmware 2.1.1 available on website and after flashing still same issue
Product purchased here: https://www.sg1shop.it/it/home/informatica/rete-networking/router/cudy-ap3000-outdoor-ax3000-high-power-wifi-6-outdoor-access-point.1.1.45.gp.10059.uw
@Dear Z,
It is strange. What the model and firmware version of your Cudy device. Please check and reply me.
“On range extender: wifi internet works, ethernet works.
On WISP: wifi internet works, ethernet no, no identification
I need WISP as for me is important to isolate the new network from the main one,I don’t want devices to be found on the same network"
On range extender: wifi internet works, ethernet works.
On WISP: wifi internet works, ethernet no, no identification
I need WISP as for me is important to isolate the new network from the main one,I don’t want devices to be found on the same network
@Dear z,
You can try to set the cudy router to range extender mode and check again?
In addition, when set WISP mode, does the WISP interface get the correct IP address from the main WiFi? What is the internet Status on the WEB page?
My setup is the same as the photo in this guide