WISP 模式：
在 WISP 模式下，路由器允許多個使用者共享 WISP 的網路連線。 LAN 埠設備透過無線連接埠與 WISP 共用相同的 IP。連接到WISP時，無線連接埠充當WAN連接埠。
常見網路拓樸：
第1 步： 開啟網路瀏覽器並前往 http://cudy.net 或 http://192.168.10.1.
詳情請參考 如何登入Cudy Router的Web介面？
第2 步： 將彈出快速設定窗口，選擇"WISP"，然後前往"下一步"。
第3 步： 選擇您的"時區"。
第4 步： 選擇您要擴充的主機網路。點選"連接"。
或點選 常規設定->WISP->啟用 然後選擇您要擴充的主機網路。
第5 步： 輸入主機網路的無線密碼。
注意： 請確保您輸入的無線密碼正確，否則設定無法成功。
第6 步： 自訂無線網路名稱和密碼或保留預設值。
第7 步： 點選"儲存並套用"完成設定。
第8 步： 等待幾秒鐘系統重新啟動，當再次彈出登入頁面時，您就可以享受網路了。
120 則留言
@Dear Daniel,
I just tested it. WR1500 takes about 1 minute to reconnect to the main Wi-Fi.
“I was curious about WISP reconnection time on WR1500. I plan to use phone wifi hotspot as WISP source. Can i expect immediate connection once i turn on phone hotspot? How long does it take to find my phone and connect to it? Also, if connection is lost, how fast cudy will reconnect to phone hotspot once it turned on again?”
I was curious about WISP reconnection time on WR1500. I plan to use phone wifi hotspot as WISP source. Can i expect immediate connection once i turn on phone hotspot? How long does it take to find my phone and connect to it? Also, if connection is lost, how fast cudy will reconnect to phone hotspot once it turned on again?
@Dear Wills,
Our technical support has sent you the firmware via email. Please check.
“Hi, can you send me WISP firmware for WR3600? thanks!”
Hi, can you send me WISP firmware for WR3600? thanks!
@Dear Wisperer,
OK. I see. The new firmware for WR3600 is under testing. We will release new firmware recently. Please wait patiently.
“Hi Cudy Support.
Im using already the Beta Firmware 2.5.5b for my WR3600 1.0 for being able to use WISP.
I found a Little bug:
Through the Cudy App i can disable WIFI completely but when trying to enable it again I get „invalid params“ error and it doesn’t get enabled again.
Through the webinterface, everything works.
Is there maybe a newer beta than 2.5.5b that addresses this issue already? Or when will there be official 2.5.X firmware?
If there is newer firmware can you provide please?!
Thank you"