Akcesoria PoE
POE20
1 2

2-Channel Gigabit PoE++ Extender

2-Channel Gigabit PoE++ Extender, POE20 1.0

POE20 1.0

A 2-channel PoE extender that splits the PoE into 2 PoE lines and extends their distance by 100m. 

  • GbE In, 2× GbE Out
  • 802.3bt/at/af Input
  • 2× 802.3at/af Max 30W Output 1
  • High-Speed/Long-Range Modes
  • High-Speed Extension up to 100 meters 2
  • Extend for 250 meters Transmission 3
  • Wall-Mount
Pokaż kompletne dane
Wersja modelu
Wersja modelu POE20 1.0
Protocols
Protocols 802.3 Protocols
  • 802.3i 10 Mbps over Twisted Pair
  • 802.3u 100 Mbps over Twisted Pair
  • 802.3ab 1 Gbps over Twisted Pair
  • 802.3x Flow Control
  • 802.3af PoE
  • 802.3at PoE
  • 802.3bt PoE
PoE
PoE Uplink Stream 1× GbE, 802.3bt/at/af
Uplink PIN Assignment Mode A / Mode B / Four-Pair
Downlink Stream 2× GbE, 802.3at/af
Downlink Pin Assignment Mode A
Transimission Distance
  • Cat. 5e or higher cable: 100 meters at Gigabit
  • Note: Distance from extender to switch depends on switch capability. Distance from extender to device follows extender rating
Transimission Distance Note 250-meter transmission is only available under the Long-Range mode.
Interfaces
Interfaces Physical Buttons High-Speed/Long-Range DIP Switch
LED
  • PoE Status of Each PoE Port
  • Link/ACT of Each Ethernet Port
Power
Power Power Input ≥60W is recommended
Max Power Output 2× 30W
Max Power Output Note The actual power output depends on input
Max Power Consumption (W) 2W
Reliability
Reliability Power Protection
  • Polarity Protection
  • Overvoltage Protection
  • Short-Circuit Protection
  • Automatic Voltage Regulation
EMC IEC/EN 61000-4-2, Level 3 ESD: Contact: 6kV; Air: 8kV
IEC/EN 61000-4-5, Level 3 Surge: RJ45: CM 2kV
Environment Ambient Operating Temperature: 0~40 ℃ (32~104 ℉)
Storage Temperature: -40~70 ℃ (-40~158 ℉)
Operating Humidity: 10%~95% non-condensing
Storage Humidity: 5%~95% non-condensing
Certifications
Certifications FCC, CE
Mechanical
Mechanical Install in a Daisy Chain Up to 3 extenders in a chain
Installation
  • Desktop
  • Wall-mount
Dimension 123×50×36 mm
4.84×1.97×1.42 inches
Casing Material Plastic
Package Content
Package Content
  • POE20
  • Mounting Kit
  • Installation Guide
  1. The actual available power equals the uplink power minus the loss on the line and device’s own power consumption (see the power consumption in the spec sheet). A PoE switch that supports standard IEEE PoE standard at 54 V is recommended.
  2. 100m extension is measured from the GbE out to the client devices. The section between uplink switch and GbE In is determined by the uplink switch.
  3. The speed will be limited at 10 Mbps under the Extend/Long-Range mode.