Cudy Whole Home Mesh system is built to eliminate dead zones and to provide uninterrupted Wi-Fi throughout your home. This article will guide you to build a mesh system step by step.
Preparation:
1. Ensure you own at least 2 Cudy products.
2. All Cudy products support mesh technology: Home Mesh-Cudy official website
3. Firmware is up-to-date: Download Center
4. Take them in the same room during configuration.
5. Reset all your Cudy products to factory default settings. (With the Power on, press and hold the RESET button with a pin for 6s, then release.)
6. Set up your primary router and make it connect to the internet.
Here we take M1800 and WR2100 as examples:
Step 1: Open a web browser and go to http://cudy.net or http://192.168.10.1.
For details, please refer to How to log into the web interface of Cudy Router?
Step 2: On the System Status page, click on the "+" button.
Step 3: Press the WPS button on the M1800 and then press the WPS button on WR2100.
Main mesh unit: Flash white
Add-on mesh unit: Flash white and red alternately
Step 4: It will go to "Scanning", then " Connecting".
Step 5: Wait until the System LED of the add-on router turns into solid blue, then relocate WR2100.
Step 6: Success and enjoy the mesh network.
Note:
1. 4/5G router can only be set up as a Main mesh unit. For example:
2. You will not able to log into the web interface of the add-on mesh router. If you want to change settings, please click on "System Status"->"Mesh".
71 comentarios
@Dear Ben,
We have released the new firmware 2.2.24 which support Cudy satellite mesh function. Please download and update. The download link is below.
https://www.cudy.com/pages/download-center/wr11000-1-0
“Is a new firmware that enables BE11000 to function in mesh with another BE11000 going to be released soon (next week or so?) Would appreciate an update – a few months ago it was supposed to be coming some time around July. Otherwise I need to return my second BE11000 to Amazon.”
Is a new firmware that enables BE11000 to function in mesh with another BE11000 going to be released soon (next week or so?) Would appreciate an update – a few months ago it was supposed to be coming some time around July. Otherwise I need to return my second BE11000 to Amazon.
@Dear Andrey,
We can talk it via email. I just sent you an email.
“No not use VLAN on switches
quote:
“Do you enable VLAN function on the L2 switch?”"
@Dear Sheikh,
What is the model of the AC1200 router you mentioned? You can check the models on the label of the router. If WR1300, then Yes.
“Can I add an AC1200 Cindy router to WR3000 WiFi router to make the AC1200 as a satellite ?”
No not use VLAN on switches
quote:
“Do you enable VLAN function on the L2 switch?”