1. Download and unzip the file from here.
2. Download the latest firmware from the official website and rename it to 'recovery.bin'. Note: You must put it in the same file of Tftpd tools.
3. Power off your Router. Unplug the power adapter or press the POWER button.
4. Connect your computer the Router's LAN port with an Ethernet cable.
5. Configure your computer's IP address to be '192.168.1.88' manually.
6. Run 'tftp32.exe'.
7. Run 'netsh advfirewall set allprofiles state off' in the command line to disable Windows firewall, otherwise tftp will be blocked. Or you can disable the firewall on the Control Panel of your computer. As shown below.
8. Press the 'Reset' button/hole and hold it. Before the Router is powered on and before tftp start to download the firmware, don't release the 'Reset' button/hole.
9. Power on the Router.
10. When the Lights are all flashing fast, or when tftp start to download the firmware, you can release the 'Reset' button/hole.
11. When the light flashes slowly, the upgrade is complete.
12. Please recover your computer's IP address to be dynamic IP.
13. Done.
142 comments
здравствуйте,на wr300 после возвращения с openwrt на официальную прошивку,поле создания/ввода пароля не активно,а под ним строка “Неверная информация о доске!”из-за чего нельзя войти в настройки устройства и настроить его.Как исправить?
@Dear Rafiur，
Sorry, the router is faulty. I suggest you to buy a new one.
“I am also having problem, showing invalid board info
In cudy m1800 v2"
I am also having problem, showing invalid board info
In cudy m1800 v2
@Dear Hans,
Sorry, we don’t offer this help as you said.
“Dear Cudy Support,
I’m working with the WR11000 (model R65) and would like to request a signed firmware based on version 2.2.16 DE, with SSH access enabled by default. This is for development and testing purposes only, and I fully accept any associated risks.
Could you provide such a firmware or let me know if it’s possible?
Thank you for your support.”
Dear Cudy Support,
I’m working with the WR11000 (model R65) and would like to request a signed firmware based on version 2.2.16 DE, with SSH access enabled by default. This is for development and testing purposes only, and I fully accept any associated risks.
Could you provide such a firmware or let me know if it’s possible?
Thank you for your support.