Cudy LTE路由器具有LAN/WAN端口，因此我們可以改變端口工作模式，並使用4G/5G網路作為上網的備援解決方案。當LAN/WAN口工作為WAN模式時，如果原有網路服務故障，路由器將連接4/5G網路。
第1步：確保4/5G網路已設定成功。
第 2 步：將路由器的 LAN/WAN 連接埠連接到數據機或網路連接埠。
注意：請確保您已有數據機或您的網路來自為您提供網路的乙太網路插座。
第 3 步：開啟網頁瀏覽器並造訪 http://cudy.net 或 http://192.168.10.1。
第 4 步：進入進階設定->LAN/WAN 交換器。
第5步：點選"切換到WAN"，路由器將重新啟動並套用設定。
第6步：設定完成後，您將在"系統狀態"頁面中看到下列狀態。
- 選擇項目後，整個頁面將重新整理。
- 在新視窗中開啟。
18 則留言
Hallo,
ich habe das gleiche Problem wie hier am 02.08.2025 geschildert:
“Hello I have internet being fed from another router (“Network A”) to my Cudy LTE Modem/Router (“Network B”). If Network A loses internet but is still working as a network (just no internet). The Cudy LTE failover does not kick in because it does not realize the internet is down. I tried changing the online detection settings but that did not work.”
@Dear H，
Our technical support has contacted you via email. Please check.
“Hello I have internet being fed from another router (“Network A”) to my Cudy LTE Modem/Router (“Network B”). If Network A loses internet but is still working as a network (just no internet). The Cudy LTE failover does not kick in because it does not realize the internet is down. I tried changing the online detection settings but that did not work.”
Hello I have internet being fed from another router (“Network A”) to my Cudy LTE Modem/Router (“Network B”). If Network A loses internet but is still working as a network (just no internet). The Cudy LTE failover does not kick in because it does not realize the internet is down. I tried changing the online detection settings but that did not work.
@Dear Molon,
The function depends on the “Advanced Setting” —“Online Check” function. Did you disable it. If yes, please enable it.
“Hello, first my cuddy Lte n300 working well on 4g. My point is I configure WAN, and when I put my câble, the router switch on WAN/4G. Until now everything is working as expected but if my main router has a connectivity issue, the cuddy router still continu to work on WAN whereas there is no more connectivity. So I don’t see the automatic switch on 4G”
Hello, first my cuddy Lte n300 working well on 4g. My point is I configure WAN, and when I put my câble, the router switch on WAN/4G. Until now everything is working as expected but if my main router has a connectivity issue, the cuddy router still continu to work on WAN whereas there is no more connectivity. So I don’t see the automatic switch on 4G