1.從 這裡。
2.從 官方網站並將其重新命名為"recovery.bin"。
3.關閉路由器電源。拔掉電源供應器或按電源按鈕。
4.使用乙太網路線將電腦連接到路由器的 LAN 連接埠。
5.手動將電腦的 IP 位址配置為"192.168.1.88"。 6.執行"tftp32.exe"。
7.在命令列中執行"netsh advfirewall set allprofiles state off"來停用Windows防火牆，否則tftp將被阻止。
8.按下"重設"按鈕/孔並按住。在路由器開機和 tftp 開始下載韌體之前，請勿放開"重設"按鈕/孔。 9.開啟路由器電源。 10。當指示燈全部快速閃爍時，或 tftp 開始下載韌體時，您可以放開"重設"按鈕/孔。
11.當燈慢閃時，升級完成。
12.請將您電腦的IP位址還原為動態IP。 13.完成。
223 則留言
Sadly this does not work with my TR3000:
1. The download link (for tftp32?) is broken/does not work.
2. It doesn’t say where to put the sysupgrade firmware after download.
3. Does the sysupgrade firmware have to be renamed (to “recovery.bin”)?
Actually the stock vendor firmware for me is better/easier than open-wrt. So it should be possible to reflash to stock fw.
@Chris,
Thank you for you help. I have sent the method “connect to the WAN port” to Ivan.
“Hi Team, I can answer myself; got it running to flash back to Cudy FW for a TR1200 by connecting to the WAN (!) Port on Cudy; not the LAN port. That was the only thing different for TR1200 compared to the the description above”Hi Team, I can answer myself; got it running to flash back to Cudy FW for a TR1200 by connecting to the WAN (!) Port on Cudy; not the LAN port. That was the only thing different for TR1200 compared to the the description above
Hi Cudy support, I do have the same issue as Ivan for TR1200.
I could download the TFTP32 for windows and follow all the steps above; but does not work to update / downgrade to original Cudy FW. Can you help?
@Stev0,
Our technical support has sent you the solutions via email. Please check.
“I recently bought a 3-pack M1800 Mesh set. I wanted try OpenWRT and flashed the firmware on all 3 M1800 units. It worked fine. I followed your instructions to return to Cudy’s firmware, i.e. to go from OpenWRT Firmware back to Cudy’s Official Firmware.”