WISP 模式：
在 WISP 模式下，路由器允許多個使用者共享 WISP 的網路連線。 LAN 埠設備透過無線連接埠與 WISP 共用相同的 IP。連接到WISP時，無線連接埠充當WAN連接埠。
常見網路拓樸：
第1 步： 開啟網路瀏覽器並前往 http://cudy.net 或 http://192.168.10.1.
詳情請參考 如何登入Cudy Router的Web介面？
第2 步： 將彈出快速設定窗口，選擇"WISP"，然後前往"下一步"。
第3 步： 選擇您的"時區"。
第4 步： 選擇您要擴充的主機網路。點選"連接"。
或點選 常規設定->WISP->啟用 然後選擇您要擴充的主機網路。
第5 步： 輸入主機網路的無線密碼。
注意： 請確保您輸入的無線密碼正確，否則設定無法成功。
第6 步： 自訂無線網路名稱和密碼或保留預設值。
第7 步： 點選"儲存並套用"完成設定。
第8 步： 等待幾秒鐘系統重新啟動，當再次彈出登入頁面時，您就可以享受網路了。
120 則留言
@Dear Ruslan,
Our technical support has sent you the firmware via email. Please check.
“Dear Support,
Could you please be so kind and send me BETA FW with WISP support for WR3600E for my own risk?
Thanks,
Ruslan (menano@mail.ru)”
Dear Support,
Could you please be so kind and send me BETA FW with WISP support for WR3600E for my own risk?
Thanks,
Ruslan (menano@mail.ru)
@Dear Kyle,
If you enable both WAN connection and WISP connection. The WAN connection will be main connection. The WISP connection will be a backup. So if you want to switch to WAN connection. You don’t need to disable WISP. But if you want to switch to WISP connection. You need to disable WAN or disconnect from the internet.
“I have an AX3000 router which needs to work in both WISP mode and with direct Ethernet port connection due to local conditions. It works with both setups if I manully change the configuration and reboot the router. My question is whether I need to enable/disable WISP when switching back and forth or will the router automatically switch if I leave WISP enabled and subsequently connect with cable to our local Ethernet network via the WAN port. My tests trying this have been inconsistent and I can’t verify it is the router or the local network configuration.”
I have an AX3000 router which needs to work in both WISP mode and with direct Ethernet port connection due to local conditions. It works with both setups if I manully change the configuration and reboot the router. My question is whether I need to enable/disable WISP when switching back and forth or will the router automatically switch if I leave WISP enabled and subsequently connect with cable to our local Ethernet network via the WAN port. My tests trying this have been inconsistent and I can’t verify it is the router or the local network configuration.
@Dear Paulo,
We have plan to add this function on next firmware 2.5.×. In addition, you need to the backhaul Wi-Fi connection will use the same channel as you set on the main Wi-Fi, can’t be changed.
“WR11000 does no allow yet to change the wifi channel manually. in WISP or wireless extender. When do you expect to make available the firmware correction?”