1.從 這裡。
2.從 官方網站並將其重新命名為"recovery.bin"。
3.關閉路由器電源。拔掉電源供應器或按電源按鈕。
4.使用乙太網路線將電腦連接到路由器的 LAN 連接埠。
5.手動將電腦的 IP 位址配置為"192.168.1.88"。 6.執行"tftp32.exe"。
7.在命令列中執行"netsh advfirewall set allprofiles state off"來停用Windows防火牆，否則tftp將被阻止。
8.按下"重設"按鈕/孔並按住。在路由器開機和 tftp 開始下載韌體之前，請勿放開"重設"按鈕/孔。 9.開啟路由器電源。 10。當指示燈全部快速閃爍時，或 tftp 開始下載韌體時，您可以放開"重設"按鈕/孔。
11.當燈慢閃時，升級完成。
12.請將您電腦的IP位址還原為動態IP。 13.完成。
162 則留言
Hello, I have a problem with the WR1500. It updated to the latest firmware from 2.3.3 to 2.3.10 and now the router is no longer responding. The LED stays red and the router restarts. I tried tftp recovery on the WAN and LAN ports, but nothing happened.
I hope you can help me. Thank you very much.
@Dear m00se,
Sorry, I think the router is faulty. We don’t have the solution to such a problem.
“Is there any solution for “Invalid board info!” on M1800 ?”
Is there any solution for “Invalid board info!” on M1800 ?
@Dear Miquel,
Yes, support.
“Good morning,
I would like to know whether the AP3000 Wall model supports TFTP recovery in the same way as the WR3000 model.
Kind regards.”
Good morning,
I would like to know whether the AP3000 Wall model supports TFTP recovery in the same way as the WR3000 model.
Kind regards.