1. 从这里下载并解压文件。
2. 从官网下载最新固件，并将其重命名为“recovery.bin”。注意：必须将其与Tftpd工具放在同一个文件中。
3. 关闭路由器。拔下电源适配器或按下电源按钮。
4. 使用以太网电缆将您的计算机连接到路由器的 LAN 端口。
5.手动将计算机的IP地址配置为“192.168.1.88”。
6. 运行‘ tftp32.exe ’。
7. 在命令行中运行“ netsh advfirewall set allprofiles state off ”以禁用 Windows 防火墙，否则 TFTP 将被阻止。或者，您也可以在计算机的“控制面板”中禁用防火墙。如下所示。
8. 按住“ Reset ”按钮/孔。在路由器通电前以及TFTP开始下载固件前，请勿松开“ Reset ”按钮/孔。
9. 打开路由器电源。
10.当所有灯都快速闪烁时，或者当 tftp 开始下载固件时，您可以松开“重置”按钮/孔。
11.当灯光慢闪时，升级完成。
12.请将您计算机的IP地址恢复为动态IP。
13.完成。
142 条评论
@Dear In Out，
Please download the Cudy official firmware for tr3000-256mb-v1 via this link.
https://d1jvyy13vm72kv.cloudfront.net/device/upgrade/m_upgrade_TR3000_256MB_Flash-R103-2.4.21-20251009-115734-sysupgrade_44834.zip
“Dear Support,
Could you please provide the stock firmware/OEM firmware for cudy tr3000-256mb-v1. Thanks in advance.”
@Dear Teodor,
I don’t understand what do you want to do. If you want to flash the router back to Cudy official firmware according to this instruction and failed. Please describe the operation details and which step you fail. May be you can record a video to show me the problem.
“Help me with the firmware on the WR1300 V2 EU i can’t get it to the stock one and i evn have a backup one but i doesnt flash and i can get it to even to pass the signal from my wan to lan to my pc and it doesnt work help me”
Dear Support,
Could you please provide the stock firmware/OEM firmware for cudy tr3000-256mb-v1. Thanks in advance.
Help me with the firmware on the WR1300 V2 EU i can’t get it to the stock one and i evn have a backup one but i doesnt flash and i can get it to even to pass the signal from my wan to lan to my pc and it doesnt work help me
@Dear Planck,
Our technical support has sent you the firmware via email. Please check.
“Dear Support,
Could you please provide the stock firmware/OEM firmware for cudy tr3000-256mb-v1. Thanks in advance.”