1. 从这里下载并解压文件。
2. 从官网下载最新固件，并将其重命名为“recovery.bin”。注意：必须将其与Tftpd工具放在同一个文件中。
3. 关闭路由器。拔下电源适配器或按下电源按钮。
4. 使用以太网电缆将您的计算机连接到路由器的 LAN 端口。
5.手动将计算机的IP地址配置为“192.168.1.88”。
6. 运行‘ tftp32.exe ’。
7. 在命令行中运行“ netsh advfirewall set allprofiles state off ”以禁用 Windows 防火墙，否则 TFTP 将被阻止。或者，您也可以在计算机的“控制面板”中禁用防火墙。如下所示。
8. 按住“ Reset ”按钮/孔。在路由器通电前以及TFTP开始下载固件前，请勿松开“ Reset ”按钮/孔。
9. 打开路由器电源。
10.当所有灯都快速闪烁时，或者当 tftp 开始下载固件时，您可以松开“重置”按钮/孔。
11.当灯光慢闪时，升级完成。
12.请将您计算机的IP地址恢复为动态IP。
13.完成。
142 条评论
@Уважаемый Владм!
Пожалуйста, следуйте этой инструкции, чтобы восстановить заводскую прошивку Cudy WR300.
Для чего нужен пароль?
“Как прошить обратно cudy wr300 на заводскую прошивку?
Пишите где ввод пароля (неверная информация)”
@Dear kozian,
For TR1200, there is a difference. You must connect your computer to WAN port of TR1200 when recovering. For TR3000, you must connect your computer to LAN port of TR1200 when recovering. Please have a check.
“@Support
>> Did you change the uboot when you update the OpenWrt firmware?
No, i did not.
I was able to restore TR3000 using another mac. I used external ethernet dongle and it seems it took to long to bring interface up. Mac mini with internal ethernet did the job fine.
With TR1200 that was not an issue btw! Perhaps due to it’s lower cpu and longer time to boot."
Как прошить обратно cudy wr300 на заводскую прошивку?
Пишите где ввод пароля (неверная информация)
@Support
>> Did you change the uboot when you update the OpenWrt firmware?
No, i did not.
I was able to restore TR3000 using another mac. I used external ethernet dongle and it seems it took to long to bring interface up. Mac mini with internal ethernet did the job fine.
With TR1200 that was not an issue btw! Perhaps due to it’s lower cpu and longer time to boot.
@Dear kozian,
Did you change the uboot when you update the OpenWrt firmware? Please tell me the steps when you update the OpenWrt firmware.
“Trying to restore official firmware on TR3000 V1 (after OpenWRT). Router does not connect to tftp server. `tcpdump arp` shows no requests from router either. Used 192.168.1.88 / 192.168.1.2 / 192.168.10.88 IP for server, Lan port. LED blinks red-white.
Need help.”