ดาวน์โหลดซอฟต์แวร์ OpenWrt

@Dear Ivan,
Our technical support has sent you the firmware via email. Please check.

“Hi,
Could you provide the OpenWrt firmware for the M3000 using the Motorcomm YT8821 (Variant 2)?
Thank you and have a nice day :)”

@Hi Mikko，
Our technical support has sent you the firmware via email. Please check.

“Hey, could you send the Cudy signed openwrt firmware to WR3000 EU1.0? The file provided in the google drive gives error “File is invalid. Please retry.””

@Dear Ben Dover,
The router M3000 can not downgrade the firmware when installed Mesh system. Please power off other satellite Mesh routers. Then reset the M3000 to factory default. Then you can downgrade the firmware before installing mesh system.

“Hi,
I want to flash OpenWRT on an M3000 with a Motorcomm YT8821 (Variant 2). I downloaded your signed firmware from your Drive, but the file hash doesn’t match the one shown in the web application. Could you confirm if you have an up to date version available?
Thanks”

Hello.
I have a Cudy M3000 V2 EU2.0, board R37.
Hardware from system log:

NAND: GigaDevice F50L1G41LB
WAN PHY: Realtek RTL8221B
Stock firmware: 2.5.28

I downloaded the official intermediary package M3000 1.0_2.0.zip.
The included file:

cudy_m3000-v1-sysupgrade_20251119.bin

causes a boot loop after flashing. Ethernet continuously connects and disconnects.

I can restore the router successfully to stock firmware via TFTP, and it works normally again.

Could you please provide the correct OpenWrt intermediary firmware for my exact hardware revision?

Thank you.
I believe a very similar case has already occurred with the same or very similar hardware parameters — M3000 V2, board R37, F50L1G41LB NAND and RTL8221B PHY — where Cudy support provided a different intermediary firmware directly to the user.
If possible, please send me the same compatible intermediary firmware for this hardware revision instead of the public cudy_m3000-v1-sysupgrade_20251119.bin.

Hi,
Could you provide the OpenWrt firmware for the M3000 using the Motorcomm YT8821 (Variant 2)?
Thank you and have a nice day :)