Dear Support,

Smart connect issue happens almost all device on my home.
Devices are- Tecno spark 30c, Tecno spark 6 air, Samsung galaxy m21, samsung galaxy A55

@Dear mahim,
Please tell me the brand and model of the devices that have this issue. We will try to find one to test it.

“Hi cudy team
I am using cudy wr3000s. V1
Firmware version- 2.4.6

I am facing an issue. When i turn on smart connect, devices disconnect from wifi and reconnect. This happens a lot.

But if i turn off smart connect, give 2.4ghz and 5ghz same name and same password, this problem never happens. I think this is a firmware bug. Please fix the issue and if there is any beta firmware you can send me that.
Thanks."

@Dear Ath Kal,
No, there is no new one.

“I am using beta firmware 2.5.4b for my CUDY WR3000 v1.0. Is there any newer beta version for it? If Yes, please send it to me. Also is there a possible release date (or even month) for a stable version of 2.5? Thank you.”

@Dear MLO and QoS,
Our technical support has sent you the firmware via email. Please check.

“Hello team. I am sitting at WR11000 V1.0 with newest official FW 2.2.25-20251112-095400.

MLO is very unstable. Causes problems in mesh mode. So I had to disable it, turning router into considerably lower tier device.

On top of this problem, QoS settings is very deficient in functionality. Limits are not enforced at all. So, device with limit 16 Mbps / 4 Mbps (2/0.5 MB/s) download/upload easily downloads at 120 Mbps spped, completely tanking latency sensitive traffic like gaming which actually needs mere 0.160 ~ 0.320 Mbps.

Secondly, while functionality of limits is already questionable. Lack of global rate limiting is rather big oversight. Because modern Android/Apple phones use MAC randomization for privacy. Therefore assigning limits manually to such devices is nothing more than short-lived setting which then clutters configuration menu.

Would you kindly send me link to latest stable beta firmware which enables proper QoS functionality?

Then, in current FW, following URL is enabled, but misbehaves:
/cgi-bin/luci/admin/services/qos/limit
It shows bunch of editable fields with: “kbytes”. Which is followed with table of currently configured QoS devices showing: “Download Rate”+"Upload Rate" as “Mbps”.
And 1st column with “MAC-Address” is partly incorrectly populated.

Confirming configuration in this broken menu will write (apply) duplicate “MAC-Address” to any number of configured devices, possibly causing even bigger problems in logic which is supposed to decide what rate limit to use. And one should wipe such table clean before setting everything again to proper values.

Thanks for your reply and work improving software for such a good hardware.
- – – -
Btw, is there technical documentation exactly describing which antenna is used for which band. If some are shared. And which should be in same orientation for best beam-forming functionality? And how this changes when router is in horizontal/vertical orientation."

Hi cudy team
I am using cudy wr3000s. V1
Firmware version- 2.4.6

I am facing an issue. When i turn on smart connect, devices disconnect from wifi and reconnect. This happens a lot.

But if i turn off smart connect, give 2.4ghz and 5ghz same name and same password, this problem never happens. I think this is a firmware bug. Please fix the issue and if there is any beta firmware you can send me that.
Thanks.