Common network topology:
Step 1: Open a web browser and go to http://cudy.net or http://192.168.10.1.
For details, please refer to How to log into the web interface of Cudy Router?
Step 2: The Quick Setup window will pop up, choose 'Wireless Extender', then go 'Next'.
Step 3: Choose your 'Time Zone'.
Step 4: Select the host network you want to extend. Click on 'Connect'.
Step 5: Enter the host network's wireless password.
Note: Make sure the wireless password you type in is correct, otherwise, the configuration cannot success.
Step 6: Customize the Wi-Fi name (SSID) and the password is the same as your host network.
Step 7: Click 'Save & Apply' to complete the configuration.
Step 8: Reconnect your wireless devices to the new Wi-Fi network.
Note:
1. If you set up the Wireless Extender mode using a wired device, this device may not have Internet after setup. Please unplug and plug the Ethernet cable or disable and enable the network adapter to acquire the new connection.
2. After setting up the Cudy router in Wireless Extender mode, the IP address will be assigned by the host router and the default IP Address 192.168.10.1 will not be able to log in. If you need to log into Cudy router again, type 'http://cudy.net' into your browser or look up the Cudy router's IP address in your host router's client list.
61 comments
@Уважаемый Владимир,
Пожалуйста, перейдите в раздел «Общие настройки» — на страницу функции «WISP». Там вы сможете включить эту функцию и настроить устройство в качестве Wi-Fi-повторителя.
“CUDY LT500D не получается настроить его как репитор. при первичной настройке нету раздела для выбора режима модема… как это можно исправить?”
CUDY LT500D не получается настроить его как репитор. при первичной настройке нету раздела для выбора режима модема… как это можно исправить?
@Dear Milt，
If you can connect the Cudy AP3000 to your network via wired cable. Please use the Access Point mode. If you can’t, you can use the wireless extender mode to connect the A3000 to the network wia Wi-Fi. Generally, if you connect the AP3000 to the network via wired cable, it will have better performance than connect the AP3000 via Wi-Fi.
“I had two Ubiquiti ap’s and I use the unifi web portal to manage the two ap’s. One died and I purchase cudy ap3000 to replace. I cannot manage the cudy ap3000 in the unifi software. I configure the cudy ap3000 with same “ssid” and “password” as the Ubiquiti ap. Work mode is “wireless access point”, should I instead set the cudy ap3000 to “wireless extender mode” to join my network? It seems to be working in access mode? Does it make a difference? If so, why?”
I had two Ubiquiti ap’s and I use the unifi web portal to manage the two ap’s. One died and I purchase cudy ap3000 to replace. I cannot manage the cudy ap3000 in the unifi software. I configure the cudy ap3000 with same “ssid” and “password” as the Ubiquiti ap. Work mode is “wireless access point”, should I instead set the cudy ap3000 to “wireless extender mode” to join my network? It seems to be working in access mode? Does it make a difference? If so, why?
@Estimado Walberto:
Intente configurar su router para que funcione en modo WISP. A continuación, compruébelo de nuevo.
“Después de que configuro mi router como extensor inalambrico, no se conecta a la red, que tengo que hacer?”