ดาวน์โหลดซอฟต์แวร์ OpenWrt

Hi, I have a Cudy WR3000H V1.0 with:
Stock firmware: 2.4.5-20250515-105059 (it came pre-installed).
I need the correct intermediate firmware to install OpenWrt on my WR3000H v1.0 (SN: WR3000H25430***** – new flash chip).

I tried flashing:

cudy_wr3000h-v1-sysupgrade_20251119.bin

The file from your official Google Drive (WR3000H 1.0.zip)

Both attempts failed with the same error at ~75%: “File is invalid. Please retry.”

Since my SN starts with 2543, I believe I need the intermediate firmware specifically for the new flash chip. Could you please send me the correct file and any special instructions?

I already emailed support@cudy.com requesting the correct OpenWrt intermediate firmware for this exact hardware revision, but I have not received a reply yet.
Could your technical support please check my email and send me the correct intermediate firmware compatible with this unit?
Thank you.
Best regards.

Hello,
Cudy M3000 V2.0, SN M3000244700186, board R37, flash F50L1G41LB (old flash), WAN PHY rtl8221b.
The intermediate firmware from your Drive (cudy_m3000-v1-sysupgrade_20251119.bin) is rejected: “File is not compatible with the device model” on stock 2.5.10, and “Incorrect firmware file” on stock 2.4.19. Could technical support send the intermediate firmware for this exact revision? I already emailed support@cudy.com.

@Dear Vince,
Our technical support has sent you the firmware via email. Please check.

“Hi, I have a Cudy WR3000H V1.0 with:
Stock firmware: 2.4.5-20250515-105059
Flash: ESMT F50L1G41LC
WAN PHY: Motorcomm YT8821
I already emailed support@cudy.com requesting the correct OpenWrt intermediate firmware for this exact hardware revision, but I have not received a reply yet.
Could your technical support please check my email and send me the correct intermediate firmware compatible with this unit?
Thank you.”

Hi, I have a Cudy WR3000H V1.0 with:
Stock firmware: 2.4.5-20250515-105059
Flash: ESMT F50L1G41LC
WAN PHY: Motorcomm YT8821
I already emailed support@cudy.com requesting the correct OpenWrt intermediate firmware for this exact hardware revision, but I have not received a reply yet.
Could your technical support please check my email and send me the correct intermediate firmware compatible with this unit?
Thank you.

@Dear Alexey,
Our technical support has contacted you via email. Please check.

“Hello. WR3000 v.1 router, S/N 2439… does not flash with OpenWRT firmware from Google Drive, it says “Incorrect firmware file”. Please help, and thank you in advance.”