ดาวน์โหลดซอฟต์แวร์ OpenWrt

Hello
The Cudy M3000 openwrt is connected to another router via the WAN port and configured as a dumb access point (wan/wan6 removed, ports added to br-lan, Firewall and DHCP disabled on LAN), but it does not work.
When a PC is connected to a LAN port on the Cudy M3000, it does not receive an IP address. If an IP address is set manually, there is still no internet access.
Please advise what additional configuration is required for the Cudy M3000 to operate correctly as a dumb AP when connected via the WAN port.

@Dear Mikhail,
Our technical support has sent you the firmware via email. Please check.

“Hello,
I have a Cudy AP3000 V1.0 access point, currently running firmware 2.4.6-20251023-141351.
I would like to safely upgrade the device to OpenWRT.
Could you please send the official intermediate firmware to my email: span530@gmail.com
?
Thank you!”

@Dear Dusan,
I just sent you the intermediate firmware for TR3000 1.0 via email. Please check.

“Hi, I can’t find intermediate firmware for tr3000 128MB, the pre-November version? The only two in the drive are the 256MB and the new November 2025 version, which is not accepted by my older tr3000. Thank you!”

Hello,

I have a Cudy AP3000 V1.0 access point, currently running firmware 2.4.6-20251023-141351.
I would like to safely upgrade the device to OpenWRT.
Could you please send the official intermediate firmware to my email: span530@gmail.com
?

Thank you!

Hi, I can’t find intermediate firmware for tr3000 128MB, the pre-November version? The only two in the drive are the 256MB and the new November 2025 version, which is not accepted by my older tr3000. Thank you!