จะสร้างเครือข่ายโฮมเมชทั้งหมดด้วยผลิตภัณฑ์ Cudy ได้อย่างไร

Can the AP1200 Outdoor be added to an existing Cudy mesh? My mesh master can’t find it while scanning.

@Dear Marc,
You can login to the webpage of the AX3000. Then click “Quick Setup”, you will find the mode options. You can choose the mode you want to set and finish the wizard.

“Thank you. To follow up from my question earlier , Sept 11:
How do I set the AX3000 , as wireless router , wireless acsess point ,wireless extender or WISP ?”

Thank you. To follow up from my question earlier , Sept 11:
How do I set the AX3000 , as wireless router , wireless acsess point ,wireless extender or WISP ?

Thank you. How do I set the AX3000 , as wireless router , wireless acsess point ,wireless extender or WISP ?

@Dear Marc Pappin,
Yes, you can install mesh system with AP3000 and M3000. Please follow the steps:
1.Keep the three M3000 in the factory default status. Power them on next to the AP3000.
2. login to the webpage of AP3000, Click + to search the mesh nodes and then add all the three M3000 to be the satellite mesh nodes.

3. After mesh installed. You can move the three M3000 to the placement you want to place it.

“Hi, could I create a network, in the following sequence : AP3000, connected via a eth.cable to a non-cudy router . Router is connected via cable to WAN

After this proves to be stable I want to extend and create a mesh with 3 M3000 , all wireless.

Can the M3000 come off the AP3000, and if so how to set up and pair?
Thanks for your help"

@Dear Marc Pappin,
Yes, you can install mesh system with AP3000 and M3000. Please follow the steps:
1.Keep the three M3000 in the factory default status. Power them on next to the AP3000.
2. login to the webpage of AP3000, Click + to search the mesh nodes and then add all the three M3000 to be the satellite mesh nodes.

3. After mesh installed. You can move the three M3000 to the placement you want to place it.

“Hi, could I create a network, in the following sequence : AP3000, connected via a eth.cable to a non-cudy router . Router is connected via cable to WAN

After this proves to be stable I want to extend and create a mesh with 3 M3000 , all wireless.

Can the M3000 come off the AP3000, and if so how to set up and pair?
Thanks for your help"