Примечание. Если устройство работает в режиме Точка доступа, гостевая сеть будет недоступна.
Шаг 1. Введите в адресной строке браузера http://cudy.net или http://192.168.10.1.
Шаг 2. Перейдите в раздел Дополнительные настройки 🡢 Гостевая сеть.
Шаг 3. Создайте гостевую сеть. По умолчанию гостевые сети Cudy не защищены паролем и называются Cudy-Guest-2.4G или Cudy-Guest-5G.
Шаг 4. Установите для параметра Шифрование значение WPA-PSK/WPA2-PSK (смешанный режим) и создайте пароль.
Шаг 5. Нажмите на кнопку Сохранить и применить. Гостевая сеть создана!
Комментариев: 88
i reported a problem about mac-filter and guest-network …
quick as the wind, sam from the support answered and sent me a firmware update that solved my problems !
best support i experienced since years or better: decades
@Уважаемый Андрей,
пожалуйста, попробуйте обновить прошивку маршрутизатора до последней версии и проверьте еще раз.
“Здравствуйте.
приобрёл M1800 V2.0, при использовании гостевой сети видна внутренняя сеть: пингуются устройства и есть доступ к внутренним сетевым ресурсам.
как это исправить ?”
Здравствуйте.
приобрёл M1800 V2.0, при использовании гостевой сети видна внутренняя сеть: пингуются устройства и есть доступ к внутренним сетевым ресурсам.
как это исправить ?
@Dear tonalt,
Our technical support has sent you the solutions via email. Please check.
“it seems that an activated mac-filter also has an effect on the guest-network in the sense that the router doesn’t connect a guest to the internet! LT700E.
i think most people don’t like this and even worse: the activated mac filter on the guest network is not editable and it even worser it doesn’t use the mac table that is defined for the main wifi network.
so the mac filter is completely useless if one allows a guest-network.
probably i am wrong and the guest network can connect a guest to the internet with an activated mac-filter. but if so, please tell what i can do, to achieve this.”
it seems that an activated mac-filter also has an effect on the guest-network in the sense that the router doesn’t connect a guest to the internet! LT700E.
i think most people don’t like this and even worse: the activated mac filter on the guest network is not editable and it even worser it doesn’t use the mac table that is defined for the main wifi network.
so the mac filter is completely useless if one allows a guest-network.
probably i am wrong and the guest network can connect a guest to the internet with an activated mac-filter. but if so, please tell what i can do, to achieve this.