WISP-režiim:
WISP-režiimis võimaldab ruuter mitmel kasutajal jagada WISPi internetiühendust. LAN-pordi seadmed jagavad sel viisil WISPist sama IP-d juhtmevaba pordi kaudu. WISPiga ühendatuna toimib traadita port nagu WAN-port.
Üldine võrgutopoloogia:
Sepp 1: Avage veebilehitseja ja minge http://cudy.net või http://192.168.10.1.
.Detailide saamiseks vaadake Kuidas sisse logida Cudy Routeri veebiliidesesse?
Samm 2: Es avaneb Quick Setup aken, valige "WISP", seejärel minge "Next".
Samm 3: Valige oma "Ajavöönd".
Sepp 4: Valige host-võrk, mida soovite laiendada. Vajutage nupule 'Connect'.
Või klõpsake Üldised sätted->WISP->Enable ja seejärel valige hostivõrk, mida soovite laiendada.
Sepp 5: Esita host-võrgu traadita võrgu parool.
Note: Vajuta, et sisestatud traadita parool oleks õige, vastasel juhul ei saa konfiguratsioon õnnestuda.
Sammu 6: Muuta traadita võrgu nimi ja parool või jäta need vaikimisi.
Sammu 7: Klikkige "Save & Apply", et lõpetada konfiguratsioon.
Sepp 8: Oota paar sekundit süsteemi taaskäivitamiseks, kui sisselogimisleht taas avaneb, võid nautida internetti.
94 comments
Dear Support,
Could you please be so kind and send me BETA FW with WISP support for WR3600E for my own risk?
Thanks,
Ruslan (menano@mail.ru)
@Dear Kyle,
If you enable both WAN connection and WISP connection. The WAN connection will be main connection. The WISP connection will be a backup. So if you want to switch to WAN connection. You don’t need to disable WISP. But if you want to switch to WISP connection. You need to disable WAN or disconnect from the internet.
“I have an AX3000 router which needs to work in both WISP mode and with direct Ethernet port connection due to local conditions. It works with both setups if I manully change the configuration and reboot the router. My question is whether I need to enable/disable WISP when switching back and forth or will the router automatically switch if I leave WISP enabled and subsequently connect with cable to our local Ethernet network via the WAN port. My tests trying this have been inconsistent and I can’t verify it is the router or the local network configuration.”
I have an AX3000 router which needs to work in both WISP mode and with direct Ethernet port connection due to local conditions. It works with both setups if I manully change the configuration and reboot the router. My question is whether I need to enable/disable WISP when switching back and forth or will the router automatically switch if I leave WISP enabled and subsequently connect with cable to our local Ethernet network via the WAN port. My tests trying this have been inconsistent and I can’t verify it is the router or the local network configuration.
@Dear Paulo,
We have plan to add this function on next firmware 2.5.×. In addition, you need to the backhaul Wi-Fi connection will use the same channel as you set on the main Wi-Fi, can’t be changed.
“WR11000 does no allow yet to change the wifi channel manually. in WISP or wireless extender. When do you expect to make available the firmware correction?”
WR11000 does no allow yet to change the wifi channel manually. in WISP or wireless extender. When do you expect to make available the firmware correction?