WISP Mode:
In WISP mode, the router allows multiple users to share the internet connection from WISP. The LAN port devices share the same IP from the WISP via the wireless port in this manner. When connected to WISP, the wireless port functions as a WAN port.
Common network topology:
Step 1: Open a web browser and go to http://cudy.net or http://192.168.10.1.
For details, please refer to How to log into the web interface of Cudy Router?
Step 2: The Quick Setup window will pop up, choose "WISP", then go "Next".
Step 3: Choose your "Time Zone".
Step 4: Select the host network you want to extend. Click on 'Connect'.
Or click on General Settings->WISP->Enable and then select the host network you want to extend.
Step 5: Enter the host network's wireless password.
Note: Make sure the wireless password you type in is correct, otherwise, the configuration cannot success.
Step 6: Customize the wireless network name and password or keep them default.
Step 7: Click "Save & Apply" to complete the configuration.
Step 8: Wait a few seconds for the system rebooting, when the login page pops up again, you can enjoy the internet.
83 comments
@Estimado Gabriel,
1. ¿Funciona cuando M3000 está al lado del router livebox6?
2. ¿Cuál es la intensidad de la señal del router livebox6 cuando en la otra parte de la casa? Si la señal es débil, puede intentar mover M3000 a otro lugar.
“Buenos dias, compre 1 cudy menhs m3000 lo configure en modo wisp con el router de livebox6 de la compañia orange y el ordenador por ethernet y se configuro.
Luego lo desenchufe y lo puse en otra parte de la casa y no conecta como wisp .
¿solo funciona cuando esta con ethernet al router?
"
Buenos dias, compre 1 cudy menhs m3000 lo configure en modo wisp con el router de livebox6 de la compañia orange y el ordenador por ethernet y se configuro.
Luego lo desenchufe y lo puse en otra parte de la casa y no conecta como wisp .
¿solo funciona cuando esta con ethernet al router?
@Dear intelcom,
For the official firmware 2.0.8, the router M1200 doesn’t support this feature. But we have added it on the new firmware update. If you need, we can send the new firmware to you.
“On M1200 can we set static IP for WISP interface that act like a client or it can only use DCHP?”
On M1200 can we set static IP for WISP interface that act like a client or it can only use DCHP?
@Dear Md Tunvir,
Thank you for contacting Cudy support team. We have plan to add this function recently.
“WR3600E is latest wifi7 router. Why it does not have the WISP option?? Please add this option just like WR3000S. Need it badly and urgently.”