1. Download and unzip the file from here.
2. Download the latest firmware from the official website and rename it to 'recovery.bin'. Note: You must put it in the same file of Tftpd tools.
3. Power off your Router. Unplug the power adapter or press the POWER button.
4. Connect your computer the Router's LAN port with an Ethernet cable.
Note: Only one model is an exception: the TR1200. The WAN port must be connected during firmware recovery. All other models use the LAN port.
5. Configure your computer's IP address to be '192.168.1.88' manually.
6. Run 'tftp32.exe'.
7. Run 'netsh advfirewall set allprofiles state off' in the command line to disable Windows firewall, otherwise tftp will be blocked. Or you can disable the firewall on the Control Panel of your computer. As shown below.
8. Press the 'Reset' button/hole and hold it. Before the Router is powered on and before tftp start to download the firmware, don't release the 'Reset' button/hole.
9. Power on the Router.
10. When the Lights are all flashing fast, or when tftp start to download the firmware, you can release the 'Reset' button/hole.
11. When the light flashes slowly, the upgrade is complete.
12. Please recover your computer's IP address to be dynamic IP.
13. Done.
254 comments
@Уважаемый Михаил,
Пожалуйста, внимательно проверьте шаги. При восстановлении необходимо подключить компьютер к порту LAN на TR3000.
“TR3000 256 v1
после установки прошивки https://4pda.to/forum/index.php?showtopic=1099628&st=5980#entry144614950 не получается вернуться на стоковую прошивку
tftp не начинает загрузку прошивки при зажатой кнопке reset
имеется backup разделов”
TR3000 256 v1
после установки прошивки https://4pda.to/forum/index.php?showtopic=1099628&st=5980#entry144614950 не получается вернуться на стоковую прошивку
tftp не начинает загрузку прошивки при зажатой кнопке reset
имеется backup разделов
@Dear Ricci,
What is the model of your Cudy device? You can check the model on the label at the bottom of the router.
“Hello, when you press the reset button and connect the power, the indicator lights up pink, but there is nothing in the program.”
Hello, when you press the reset button and connect the power, the indicator lights up pink, but there is nothing in the program.