PoE 配件
POE10

Max 250 m Distance

Connect Further. Deploy Flexibly.

Choose the high-speed mode to establish a PoE Gigabit connection that spans for another 100 m, or long-range mode to prolong the connection to 250 m by limiting the speed at 10 Mbps.

Max 250 m Distance

Connect Further. Deploy Flexibly.

Choose the high-speed mode to establish a PoE Gigabit connection that spans for another 100 m, or long-range mode to prolong the connection to 250 m by limiting the speed at 10 Mbps.

Built for Consistent Networking 24/7

Shields Against Static Discharge

Dry office environment may harm the client with static discharge, and POE10 is equipped with level 3 ESD protection, handling 6kV contact and 8kV air ESD.

Tri-Level Client Protections

Provide more reliable networking with short-circuit protection, overvoltage protection, and polarity protection.

High-Speed. Plug and Play.

Gigabit Speed

Provides super-fast bandwidth suitable for connecting multiple cameras, high-speed access points, speakers down the line. *Connecting mulitple clients requries additional network switch at its end.

Wall-Mount Ready

Installation is straightforward with no configuration required. Mounting screws are included in the box.

FAQ

  1. What is a PoE Extender?
    A PoE Extender allows you to extend both power and data over Ethernet beyond the standard 100 m (328 ft) limit. It receives PoE input from a PoE switch or injector and outputs power and data to the next device or another extender.
  2. Can I connect a PoE Extender directly to a non-PoE switch?
    No. A non-PoE switch does not provide power through Ethernet.
    You must use a PoE injector between the switch and the extender to supply power if you do not have a PoE switch.
  3. My PoE Extender is not working. What should I check first?
    Please verify the following:
  • The upstream device (switch or injector) supports PoE or PoE+ (802.3af/at).
  • Non-PoE switches cannot power the extender.
  • The Ethernet cable is Cat5e or higher, in good condition, and under 100 m per segment.
  • The total chain length (from the switch to the final device) does not exceed the maximum supported distance.
  • The powered device (PD), such as a camera or AP, does not exceed the extender’s PoE output capacity.
1 3

千兆 PoE 中继延长器

千兆 PoE 中继延长器, POE10 2.0

POE10 2.0

千兆 PoE 中继延长器，默认状态可将 PoE 距离延长 100 米，Extend 模式打开后，将速率限为 10Mbps 后延长PoE 距离 250 米。

  • 千兆以太网输入/输出
  • 802.3at/af 标准，最大输出功率 30W 1
  • 802.3at/af 输入
  • 高速模式/延长模式切换开关
  • 延长距离达 100 米 2
  • 支持进一步延长传输距离达 250米 3
  • 壁挂安装
查看完整详细信息
型号版本
型号版本 POE10 2.0
Protocols
Protocols 802.3 Protocols
  • 802.3i 10 Mbps over Twisted Pair
  • 802.3u 100 Mbps over Twisted Pair
  • 802.3ab 1 Gbps over Twisted Pair
  • 802.3x Flow Control
  • 802.3af PoE
  • 802.3at PoE
PoE
PoE Uplink Stream 1× GbE, 802.3at/af
Uplink PIN Assignment Mode A / Mode B
Downlink Stream 1× GbE, 802.3at/af
Downlink Pin Assignment Mode A
Transimission Distance
  • Cat. 5e or higher cable: 100 meters at Gigabit
  • Cat. 5e or higher cable: 250 meters at 10 Mbps
  • Note: Distance from extender to switch depends on switch capability. Distance from extender to device follows extender rating
Transimission Distance Note 250-meter transmission is only available under the Long-Range mode.
Interfaces
Interfaces Physical Buttons High-Speed/Long-Range DIP Switch
LED
  • PoE Status of Each PoE Port
  • Link/ACT of Each Ethernet Port
Power
Power Power Methods 802.3at/af PoE
Passive PoE Input 48V
Power Input ≥30W is recommended
Max Power Output 30W
Max Power Output Note The actual power output depends on input
Max Power Consumption (W) 2W
Reliability
Reliability Power Protection
  • Polarity Protection
  • Overvoltage Protection
  • Short-Circuit Protection
EMC IEC/EN 61000-4-2, Level 3 ESD: Contact: 6kV; Air: 8kV
IEC/EN 61000-4-5, Level 3 Surge: RJ45: CM 2kV
Environment Ambient Operating Temperature: 0~40 ℃ (32~104 ℉)
Storage Temperature: -40~70 ℃ (-40~158 ℉)
Operating Humidity: 10%~95% non-condensing
Storage Humidity: 5%~95% non-condensing
Certifications
Certifications FCC, CE
Mechanical
Mechanical Install in a Daisy Chain Up to 3 extenders in a chain
Installation
  • Desktop
  • Wall-mount
Dimension Main Part:
80.1×48.9×31.9 mm
3.15×1.93×1.26 inches
Each Bracket:
9 mm
0.35 inches
Casing Material Plastic
Product Weight 58.4 g (2.06 oz.)
Package Content
Package Content
  • POE10
  • Mounting Kit
  • Installation Guide
Ordering Information
Ordering Information Retail Package Dimension 106.5×53×40 mm
4.19×2.09×1.57 inches
Retail Package Weight 89.0 g (3.14 oz.)
Units per Carton 100
Carton Net Weight 8.9 kg (19.62 lbs)
Carton Gross Weight 9.5 kg (20.94 lbs)
Carton Dimension 45.2×22×29.4 cm
17.8×8.66×11.57 inches
  1. 实际可用功率 = 上行供电功率 − 线路损耗 − 设备自身功耗（功耗详情请参见规格表）。建议上行供电使用支持标准 IEEE PoE（54V）的 PoE 交换机或 PoE 适配器。
  2. 100米延长距离的测量是从 GbE Out 口到客户端设备。上行交换机到 GbE In 口之间的距离由上行交换机决定。
  3. 需要打开机身 Extend/Long-Range 开关，传输速率将被限制在 10 Mbps。