常见网络拓扑：
步骤 1：将范围扩展器插入墙上插座，等待电源灯稳定亮起。
笔记：
1. 当您设置范围扩展器时，请将其靠近主机路由器。
2. 将范围扩展器重置为默认设置以避免接口。
第 2 步：连接到 Range Extender 的默认 Wi-Fi，即开放的 Wi-Fi。
步骤 3 ：启动网络浏览器，在地址栏中输入http://cudyre.net/或http://192.168.10.254/ 。
弹出如下登录页面，选择网页管理页面的显示语言，要求密码为“ admin ”或者需要创建一个密码。
步骤 4：将弹出快速设置窗口，选择“无线扩展器” ，然后转到“下一步” 。
第 5 步：选择您的“时区”。
步骤6：选择要扩展的主机网络。单击“连接” 。
第七步：输入主路由器的无线密码。
注意：请确保输入的无线密码正确，否则配置无法成功。
第八步：自定义WiFi名称（SSID），密码与您的主机网络相同。
步骤9：单击“保存并应用”完成配置。
第十步：将您的无线设备重新连接到新的 Wi-Fi 网络。
笔记：
配置完成后，分配的 IP 地址将不再是 192.168.10.254。要再次登录 Cudy Extender，请访问“http://cudyre.net”或在路由器的客户端列表中查找 IP 地址。
13 条评论
My exteneder just flash light and then turns off and dose not show the word mange router as usual and when i link it to the router the lock light is the only bright light
@Dear George,
Please try to enable the “MAC Repeater” function on the “Advanced Settings” page. Then check if the problem remains?
If yes, you can also try to set it to WISP mode.
“Hello, I have the AP1300 outdoors and I am using it as an extender. Although I set it up successfully and I can connect with very good speeds after a few hours all my devices are disconnected and cannot obtain IP. My router IP is 192.168.2.1. My provider tried to make some settings, even try a static ip with with range but again after a few hours all devices are disconnected. Is the repeater IP the same as my router’s? In the cudy app it notes that my IP is 192.168.10.254. My service provider says that this might be the problem. Please help me to solve this, when the devices works it really works great. Thank you in advance, George”
Hello, I have the AP1300 outdoors and I am using it as an extender. Although I set it up successfully and I can connect with very good speeds after a few hours all my devices are disconnected and cannot obtain IP. My router IP is 192.168.2.1. My provider tried to make some settings, even try a static ip with with range but again after a few hours all devices are disconnected. Is the repeater IP the same as my router’s? In the cudy app it notes that my IP is 192.168.10.254. My service provider says that this might be the problem. Please help me to solve this, when the devices works it really works great. Thank you in advance, George
@Claudia,
You can try to reset the device to factory default and set it up again. If the device is faulty, such as the LED will not power on. I suggest you to contact the seller to request a warranty.
“Hi
My extender just stopped working”
Hi
My extender just stopped working