Common network topology:
Step 1: Plug the Range Extender into the wall socket and wait until the Power light is Stable on.
Note:
1. When you set up the Range Extender, take it closer to your host router.
2. RESET the Range Extender to default settings to avoid interfaces.
Step 2: Connect to the Range Extender's default Wi-Fi which is open Wi-Fi.
Step 3: Launch a web browser, and enter http://cudyre.net/ or http://192.168.10.254/ in the address bar.
The login page below will pop up. Choose the display language of the web management page and the requested password is 'admin' or need to create one password.
Step 4: The Quick Setup window will pop up, choose 'Wireless Extender', then go 'Next'.
Step 5: Choose your "Time Zone".
Step 6: Select the host network you want to extend. Click on 'Connect'.
Step 7: Enter the host router's wireless password.
Note: Make sure the wireless password you type in is correct, otherwise, the configuration cannot succeed.
Step 8: Customize the WiFi name (SSID) and the password is the same as your host network.
Step 9: Click 'Save & Apply' to complete the configuration.
Step 10: Reconnect your wireless devices to the new Wi-Fi network.
Note:
After configuration, the assigned IP address will not be 192.168.10.254. To log into Cudy Extender again, visit 'http://cudyre.net' or find the IP address in the router's client list.
13 comentarios
My exteneder just flash light and then turns off and dose not show the word mange router as usual and when i link it to the router the lock light is the only bright light
@Dear George,
Please try to enable the “MAC Repeater” function on the “Advanced Settings” page. Then check if the problem remains?
If yes, you can also try to set it to WISP mode.
“Hello, I have the AP1300 outdoors and I am using it as an extender. Although I set it up successfully and I can connect with very good speeds after a few hours all my devices are disconnected and cannot obtain IP. My router IP is 192.168.2.1. My provider tried to make some settings, even try a static ip with with range but again after a few hours all devices are disconnected. Is the repeater IP the same as my router’s? In the cudy app it notes that my IP is 192.168.10.254. My service provider says that this might be the problem. Please help me to solve this, when the devices works it really works great. Thank you in advance, George”
Hello, I have the AP1300 outdoors and I am using it as an extender. Although I set it up successfully and I can connect with very good speeds after a few hours all my devices are disconnected and cannot obtain IP. My router IP is 192.168.2.1. My provider tried to make some settings, even try a static ip with with range but again after a few hours all devices are disconnected. Is the repeater IP the same as my router’s? In the cudy app it notes that my IP is 192.168.10.254. My service provider says that this might be the problem. Please help me to solve this, when the devices works it really works great. Thank you in advance, George
@Claudia,
You can try to reset the device to factory default and set it up again. If the device is faulty, such as the LED will not power on. I suggest you to contact the seller to request a warranty.
“Hi
My extender just stopped working”
Hi
My extender just stopped working