1. Download and unzip the file from here.
2. Download the latest firmware from the official website and rename it to 'recovery.bin'. Note: You must put it in the same file of Tftpd tools.
3. Power off your Router. Unplug the power adapter or press the POWER button.
4. Connect your computer the Router's LAN port with an Ethernet cable.
Note: Only one model is an exception: the TR1200. The WAN port must be connected during firmware recovery. All other models use the LAN port.
5. Configure your computer's IP address to be '192.168.1.88' manually.
6. Run 'tftp32.exe'.
7. Run 'netsh advfirewall set allprofiles state off' in the command line to disable Windows firewall, otherwise tftp will be blocked. Or you can disable the firewall on the Control Panel of your computer. As shown below.
8. Press the 'Reset' button/hole and hold it. Before the Router is powered on and before tftp start to download the firmware, don't release the 'Reset' button/hole.
9. Power on the Router.
10. When the Lights are all flashing fast, or when tftp start to download the firmware, you can release the 'Reset' button/hole.
11. When the light flashes slowly, the upgrade is complete.
12. Please recover your computer's IP address to be dynamic IP.
13. Done.
245 comentarios
Как прошить обратно cudy wr300 на заводскую прошивку?
Пишите где ввод пароля (неверная информация)
@Support
>> Did you change the uboot when you update the OpenWrt firmware?
No, i did not.
I was able to restore TR3000 using another mac. I used external ethernet dongle and it seems it took to long to bring interface up. Mac mini with internal ethernet did the job fine.
With TR1200 that was not an issue btw! Perhaps due to it’s lower cpu and longer time to boot.
@Dear kozian,
Did you change the uboot when you update the OpenWrt firmware? Please tell me the steps when you update the OpenWrt firmware.
“Trying to restore official firmware on TR3000 V1 (after OpenWRT). Router does not connect to tftp server. `tcpdump arp` shows no requests from router either. Used 192.168.1.88 / 192.168.1.2 / 192.168.10.88 IP for server, Lan port. LED blinks red-white.
Need help.”
@Уважаемый мэрт,
Вы изменили uboot при обновлении прошивки OpenWrt?
“здравствуйте произошли некоторые проблемы с роутером куди tr30
суть такая что я попытался установить openwrt ( получилось)
скачав его. попытался настроить его, но ничего не вышло.
у меня очнь странное подключение интернета
тк мой провайдер поставил свой роутер( там другой подключение не эзернет провод)
и после поделючил к куди.
после не смог сделать свои настройки через openwrt
и захотел обратно вернуться на прошивку куди. но ничего не выходит
пытался все сделать по гайду но не вышло. помогите пожалуйста”
Trying to restore official firmware on TR3000 V1 (after OpenWRT). Router does not connect to tftp server. `tcpdump arp` shows no requests from router either. Used 192.168.1.88 / 192.168.1.2 / 192.168.10.88 IP for server, Lan port. LED blinks red-white.
Need help.