What is Access Point Mode?
Access Point mode is the router uses a wired connection to the primary router or modem router to expand the wireless coverage for a home network.
Common network topology:
Step 1: Open a web browser and go to http://cudy.net or http://192.168.10.1.
For details, please refer to How to log into the web interface of Cudy Router?
Step 2: The Quick Setup window will pop up, choose 'Wireless Access Point', then click 'Next'.
Step 3: Choose your 'Time Zone'.
Step 4: Confirm the hardware connection.
Step 5: Change the wireless network name and password.
Step 6: Click "Save & Apply" to complete the configuration.
Step 7: Wait a few seconds for the system rebooting, when the login page pops up again, you can enjoy the internet.
Note:
After setting up the Cudy router into Access Point mode, the IP address will be assigned by the host router and the default IP Address 192.168.10.1 will not able to log in. If you need to log into Cudy router again, type 'http://cudy.net' into your browser or look up the Cudy router's IP address in your main (primary) router's client list.
52 comments
@Dear Kala,
Please run the quick setup wizard. Then you can choose the working mode.
“Just downloaded the app and it does not have “mode” option.
How to connect as extender?”
Just downloaded the app and it does not have “mode” option.
How to connect as extender?
@Dear J,
AP3600 supports Mesh function. You can install mesh system with two AP3600.
In addition, you can also use the M3600 (which work as the Access Point mode) to install mesh with AP3600.
“Hello, if I get AP3600 ceiling mount access point, am I able to form a mesh with only two or more AP3600, or do I need an additional controller unit like a M3600 or C200P?
Alternatively, if I get one AP3600 and one M3600, and I set the M3600 to Wireless Access Point mode, can it still act as a controller for the AP3600?"
Hello, if I get AP3600 ceiling mount access point, am I able to form a mesh with only two or more AP3600, or do I need an additional controller unit like a M3600 or C200P?
Alternatively, if I get one AP3600 and one M3600, and I set the M3600 to Wireless Access Point mode, can it still act as a controller for the AP3600?
@Dear Buhle,
What is the problem like? Please tell more details about this issue.
“Good day
I purchased a AP3000 however when setup as a AP mode it works a router. Can you kindly assist"